LANTIME M300/GNS -  (for GPS, Glonass, Galileo und Beidou-Synchronisation)

NTP time server for 19" installation
with management CPU and internal time reference:
Multi-GNSS satellite receiver/radio clock with TCXO Timebase *)
- GPS/GNSS antenna input, SMA female connector

2 x LAN interface 10/100 Mbit, RJ45 connector
1 x Terminal RS232 interface, 9pin D-Sub male connector
for initial setup and configuration
1 x USB Service interface
1 x LC-Display (2 x 40 characters) and 8 push buttons
----------------------------------------------------------------------------------------------
Signal Outputs:
2 x RS232 interface, independent, 9pin D-Sub female connector,
with multi data formats timestrings.
1 x PPS, TTL into 50 ohm, pulse duration 200 msec,
active high, female BNC connector
1 x Standard Frequency 10 MHz, TTL into 50 ohm, female BNC connector
1 x Alarm Relay Output, change-over contact, 3pin DFK connector
3 x Programmable Pulse output (E.g. PPS; PPM; PPH; DCF_Mark..)
2.5Vpp into 50 ohm, via female BNC connector
----------------------------------------------------------------------------------------------
Technical specifications:
Power supply: 100-240 V AC (50-60 Hz)
Power consumption: max. 30 W
19" metal chassis, 1 U/84 HP
(483 mm wide x 43 mm high x 285 mm deep)
----------------------------------------------------------------------------------------------