LANTIME M300/GPS-DHQ/EC-1-1/EF-1-1

http://www.meinberg.de/english/products/lantime-m300-gps.htm

NTP time server for 19" installation
with management CPU and internal time reference:
GPS satellite receiver/radio clock with OCXO-DHQ Timebase *)
- Meinberg GPS antenna input,  BNC female connector, isolated
2 x LAN interface 10/100 MBit, RJ45 connector
1 x Terminal RS232 interface, 9pin D-Sub male connector
      for initial setup and configuration
1 x USB Service interface
1 x LC-Display (2 x 40 characters) and 8 push buttons
----------------------------------------------------------------------------------------------
Signal Outputs:
2 x RS232 interface, independent, 9pin D-Sub female connector,
      with multi data formats timestrings.
1 x PPS, TTL into 50 ohm, pulse duration 200 msec,
      active high, female BNC connector
1 x Standard Frequency 10 MHz, TTL into 50 ohm, female BNC connector
1 x Alarm Relay Output, change-over contact, 3pin DFK connector

additional outputs LIU:
----------------------------------
1 x 2048 kHz (E1-mode), G.703, 75 ohm, unbalanced, via BNC connector
1 x 2048 kHz (E1-mode), 120 ohm, balanced, via RJ45 connector
1 x 2.048 Mbps (E1-mode), 75 ohm , unbalanced, via BNC connector
1 x 2.048 Mbps (E1-mode), 120 ohm , balanced, via RJ45 connector
----------------------------------------------------------------------------------------------
Technical specifications:
Power supply: 100-240 V AC (50-60 Hz)
Power consumption: max. 30 W
19" metal chassis, 1 U/84 HP
(483 mm wide x 43 mm high x 285 mm deep)
----------------------------------------------------------------------------------------------
Scope of supply:
The system will be delivered inclusive of GPS/Converter
outdoor antenna, mounting kit and 20 m  coax-cable (RG58).